hardware-based enable (ICMP jitter test instance)

Function

The hardware-based enable command enables the hardware forwarding engine on the interface board to send packets and add timestamps to the packets during an ICMP jitter test.

The undo hardware-based command disables the hardware forwarding engine on the interface board from sending packets or adding timestamps to the packets during an ICMP jitter test.

By default, the hardware forwarding engine on an interface board is disabled from sending packets or adding timestamps to the packets.

Format

hardware-based enable

undo hardware-based

Parameters

None

Views

NQA view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
sla	write

Usage Guidelines

Usage Scenario

When ICMP Jitter test are performed, the hardware forwarding engine on the interface board needs to be enabled to send packets and timestamp. In this case, you need to configure the hardware-based enable.

Configuration Impact

After the hardware-based enable command is run, the sendpacket passroute command can be configured but does not take effect.

Example

# Enable the hardware forwarding engine on the interface board to send packets and add timestamps to the packets.

<HUAWEI> system-view
[~HUAWEI] nqa test-instance admin jitter
[*HUAWEI-nqa-admin-jitter] test-type icmpjitter
[*HUAWEI-nqa-admin-jitter] hardware-based enable