The nat traversal command enables NAT traversal.
The undo nat traversal command restores the default setting.
By default, the NAT traversal is disabled.
This command is supported only on the NetEngine 8000 F1A.
nat traversal
undo nat traversal
IKE peer view
2: Configuration level
Usage Scenario
When a NAT gateway is deployed between the two peers of an IPSec tunnel, you need to enable the NAT traversal function.
<HUAWEI> system-view [~HUAWEI] ike peer peer1 [*HUAWEI-ike-peer-peer1] nat traversal
