The remote-id command configures the remote ID for an IKE peer.
The undo remote-id command cancels the configuration.
By default, the remote ID for an IKE peer is not configured.
This command is supported only on the NetEngine 8000 F1A.
remote-id remote-id
undo remote-id
Indicates the ID of the peer.
It is a string of 1 to 255 case sensitive characters.
IKE peer view
2: Configuration level
Do not run this command if the IKE peer ID is in the IP address format.
<HUAWEI> system-view [~HUAWEI] ike peer peer1 [*HUAWEI-ike-peer-peer1] remote-id huawei100
