rip enable

Function

The rip enable command enables a RIP process on an interface.

The undo rip enable command disables a RIP process from an interface.

By default, no RIP process is enabled on an interface.

Format

rip enable process-id

undo rip enable

Parameters

Parameter	Description	Value
process-id	Indicates the ID of a RIP process.	The value is an integer ranging from 1 to 4294967295.

Parameter

Description

Value

process-id

Indicates the ID of a RIP process.

The value is an integer ranging from 1 to 4294967295.

Views

100GE interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk interface view, FlexE interface view, GE optical interface view, GE electrical interface view, GMPLS-UNI interface view, Global VE sub-interface view, Loopback interface view, Tunnel interface view, VBDIF interface view, VE sub-interface view, VLANIF interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
rip	write

Usage Guidelines

Usage Scenario

To enable a RIP process on an interface, run the rip enable command.

After the rip enable command is run on an interface, routes to all the network segments where the interface is located are advertised using RIP packets.

NOTE:

The rip enable command takes precedence over the network command.

Example

# Enable RIP process 1 on an interface.

<HUAWEI> system-view
[~HUAWEI] rip 1
[*HUAWEI] quit
[*HUAWEI] interface GigabitEthernet 0/1/0
[*HUAWEI-GigabitEthernet0/1/0] rip enable 1