ripng enable

Function

The ripng enable command enables RIPng on an interface.

The undo ripng command disables RIPng from an interface.

By default, RIPng is disabled on an interface.

Format

ripng process-id enable

undo ripng

Parameters

Parameter	Description	Value
process-id	Specifies the ID of a RIPng process.	The value is an integer ranging from 1 to 4294967295.

Parameter

Description

Value

process-id

Specifies the ID of a RIPng process.

The value is an integer ranging from 1 to 4294967295.

Views

100GE interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk interface view, FlexE interface view, GE optical interface view, GE electrical interface view, GMPLS-UNI interface view, Global VE sub-interface view, Loopback interface view, Tunnel interface view, VE sub-interface view, VLANIF interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
ripng	write

Usage Guidelines

Usage Scenario

To enable RIPng on an interface, run the ripng enable command. Ensure that an IPv6 address has been configured for the interface before you run this command; otherwise, this command cannot be run.

Example

# Enable RIPng 100 on GigabitEthernet 0/1/0.

<HUAWEI> system-view
[~HUAWEI] ripng 100
[*HUAWEI-ripng-100] quit
[*HUAWEI] interface GigabitEthernet 0/1/0
[*HUAWEI-GigabitEthernet0/1/0] ipv6 enable
[*HUAWEI-GigabitEthernet0/1/0] ipv6 address 2001:db8::1/64
[*HUAWEI-GigabitEthernet0/1/0] ripng 100 enable