ip-pool route auto-refresh

Function

The ip-pool route auto-refresh disable command disables auto-refresh of address pool routes.

The undo ip-pool route auto-refresh disable command restores the default configuration.

By default, auto-refresh of address pool routes is enabled.

This command is supported only on the NetEngine 8000 F1A.

Format

ip-pool route auto-refresh disable

undo ip-pool route auto-refresh disable

Parameters

None

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
ippool	write

Usage Guidelines

Usage Scenario

When a gateway is configured for IPv4 local and remote address pools, network segment routes are generated for forwarding user traffic to the local device. If the network segment routes of the address become unavailable or are incorrectly deleted, user traffic cannot be forwarded to the local device, causing user login failures. This problem can be resolved by auto-refresh of address pool routes.

However, if incorrect routes are repeatedly generated for IP addresses in the address pool, run the ip-pool route auto-refresh disable command to disable auto-refresh of address pool routes.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Disable auto-refresh of address pool routes.

<HUAWEI> system-view
[~HUAWEI] ip-pool route auto-refresh disable