lmp static

Function

The lmp static command enables static LMP.

The undo lmp static command disables static LMP.

By default, static LMP is disabled.

lmp static

undo lmp static

None

LMP neighbor view

2: Configuration level

Task Name	Operations
lmp	write

Usage Scenario

LMP is used in GMPLS to manage the links of the control channel and data channel. LMP is classified into the following types:

Static LMP: LMP neighbors, the control channel, and the data channel are all manually configured, and therefore no dynamic LMP negotiation is required.
Dynamic LMP: LMP neighbors, the control channel, and the data channel can all be automatically discovered. This minimizes configurations and speeds up network deployment.
At present, the device supports static LMP only. The lmp static command can be run only after LMP is enabled globally and an LMP neighbor is specified on the VRP.

Prerequisites

The peer (LMP view) command has been run to configure an LMP neighbor.

# Enable static LMP.

<HUAWEI> system-view
[~HUAWEI] lmp
[*HUAWEI-lmp] peer test
[*HUAWEI-lmp-peer-test] lmp static