lns-group

Function

The lns-group command creates an LNS group and displays its view.

The undo lns-group command deletes the LNS group.

By default, no LNS group is created.

This command is supported only on the NetEngine 8000 F1A.

Format

lns-group group-name

undo lns-group group-name

Parameters

Parameter Description Value
group-name

Specifies the name of an LNS group.

It is a string of 1 to 30 characters.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name Operations
l2tp write

Usage Guidelines

Usage Scenario

Each LNS group uses the IP address of the bound interface as the source address to communicate with the LAC. The device can determine the LNS group that processes the tunnel connection request from an LAC.

On the device, you can configure multiple tunnel boards and specify a tunnel board for an LNS. Multiple tunnel boards can be bound to an LNS group. These tunnel boards bear the load in turn based on tunnels.

Precautions

Running the undo lns-group command fails if the LNS group has tunnels.

Example

# Create an LNS group named backgroup.
<HUAWEI> system-view
[~HUAWEI] lns-group backgroup
Parent Topic: L2TP Access Configuration Commands
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >