loop-detect packet priority

Function

The loop-detect packet priority command configures the priority of loop-detect protocol packet.

The undo loop-detect packet priority command restores the priority of loop-detect protocol packet.

By default, the priority of loop-detect protocol packet is 6.

Format

loop-detect packet priority priority-value

undo loop-detect packet priority

Parameters

Parameter	Description	Value
priority-value	Specifies the priority of loop-detect protocol packet.	The value is an integer ranging from 0 to 7.

Parameter

Description

Value

priority-value

Specifies the priority of loop-detect protocol packet.

The value is an integer ranging from 0 to 7.

Views

Eth-Trunk sub-interface view, Eth-Trunk interface view, GE sub-interface view, GE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
vlan	write

Usage Guidelines

Usage Scenario

The loop-detect packet priority command can be configured on an interface only after loop detection is enabled globally and the loop-detect enable command is configured on the sub-interface.

Example

# Configure the priority of loop-detect protocol packet of GE0/1/0.1 as 3.

<HUAWEI> system-view
[~HUAWEI] loop-detection enable
[*HUAWEI] interface GigabitEthernet 0/1/0.1
[*HUAWEI-GigabitEthernet0/1/0.1] loop-detect enable
[*HUAWEI-GigabitEthernet0/1/0.1] loop-detect packet priority 3