fail-percent (LSP Ping test instance)

Function

The fail-percent command sets the failure percent threshold for an NQA test instance of LSP Ping test type.

The undo fail-percent command deletes the failure percent threshold.

By default, the failure percent threshold is 100. A test is considered failed only after all probes fail.

Format

fail-percent percent

undo fail-percent

Parameters

Parameter	Description	Value
percent	Specifies the percent threshold of the failed NQA probes.	The value is an integer that ranges from 1 to 100.

Parameter

Description

Value

percent

Specifies the percent threshold of the failed NQA probes.

The value is an integer that ranges from 1 to 100.

Views

NQA view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
sla	write

Usage Guidelines

Usage Scenario

A test consists of several probes. On an unreliable network, the probe-count command can be used to set the number of probes for an NQA test instance. The analysis on statistics about probe packets helps you monitor network quality.

Some or all sent probe packets may be discarded. In this case, you can run the fail-percent command to set the failure percent threshold. When the number of failed probes reaches the specified percent threshold, the test is considered failed.

For example, 10 probes are set using the probe-count command, and seven probes fail.

If the failure percent threshold is set to 80, the probe failure percentage (70%) is lower than 80%, and therefore, the test instance is successful.
If the failure percent threshold is set to 60, the probe failure percentage (70%) is higher than 60%, and therefore, the test instance fails.

Precautions

If parameters need to be changed during the running of the test instance, the system prompts you whether to terminate the test instance. Press "Y" or "N" as required.

If you press "Y", the test instance is terminated and parameters changed. The settings take effect after being committed. To restart the test instance, run the start command.
If you press "N", the test instance keeps running, and the parameters fail to be modified.

Example

# Set the failure percent threshold to 10 for a test instance named user test.

<HUAWEI> system-view
[~HUAWEI] nqa test-instance user test
[*HUAWEI-nqa-user-test] test-type lspping
[*HUAWEI-nqa-user-test] fail-percent 10