The multicast bgp-connector compatible command enables connector attribute compatibility.
The undo multicast bgp-connector compatible command restores the default setting.
By default, connector attribute compatibility is not enabled.
Usage Scenario
In mLDP In-Band MVPN scenarios, the Connector attribute in compatible mode carries the RD and IP address (MVPN ID) of the headend device.
When the multicast bgp-connector compatible command is run and an MVPN ID is configured, the Connector attribute (RD:IP) in compatible mode is sent to the remote MP-BGP peer through BGP. When the multicast bgp-connector compatible command is disabled and an MVPN ID is configured, the Connector attribute in compatible mode is withdrawn, and the extended community attribute is sent to the remote MP-BGP peer through BGP.<HUAWEI> system-view [~HUAWEI] ip vpn-instance vrf1 [~HUAWEI-vpn-instance-vrf1] ipv4-family [*HUAWEI-vpn-instance-vrf1-af-ipv4] route-distinguisher 2:2 [*HUAWEI-vpn-instance-vrf1-af-ipv4] vpn-target 1:1 both [*HUAWEI-vpn-instance-vrf1-af-ipv4] multicast routing-enable [*HUAWEI-vpn-instance-vrf1-af-ipv4] multicast inband-signaling mldp [*HUAWEI-vpn-instance-vrf1-af-ipv4] multicast bgp-connector compatible