pim mib-notification interval

Function

The pim mib-notification interval command sets the interval for PIM to send trap messages about various events.

The undo pim mib-notification interval command restores the default interval for PIM to send various trap messages.

By default, an alarm is generated only when a neighbor loss event or a neighbor addition event occurs. No alarm is generated when the other events occur.

Format

pim mib-notification interval { interface-election-dr election-value | invalid-join-prune jp-value | invalid-register register-value | neighbor-loss loss-value | new-neighbor new-value | rp-mapping-change change-value }

undo pim mib-notification interval all

undo pim mib-notification interval interface-election-dr

undo pim mib-notification interval invalid-join-prune

undo pim mib-notification interval invalid-register

undo pim mib-notification interval neighbor-loss

undo pim mib-notification interval new-neighbor

undo pim mib-notification interval rp-mapping-change

Parameters

Parameter	Description	Value
interface-election-dr election-value	Specifies the minimum interval for sending trap messages about designated router (DR) election.	The value is an integer that ranges from 0 to 65535, in seconds. The default value is 65535 seconds.
invalid-join-prune jp-value	Specifies the minimum interval for sending trap messages about invalid Join/Prune messages.	The value is an integer that ranges from 10 to 65535, in seconds. The default value is 65535 seconds.
invalid-register register-value	Specifies the minimum interval for sending trap messages about invalid Register messages.	The value is an integer that ranges from 10 to 65535, in seconds. The default value is 65535 seconds.
neighbor-loss loss-value	Specifies the minimum interval for sending trap messages about neighbor loss.	The value is an integer that ranges from 0 to 65535, in seconds. The default value is 0 seconds.
new-neighbor new-value	Specifies the minimum interval for sending trap messages about neighbor addition.	The value is an integer that ranges from 0 to 65535, in seconds. The default value is 0 seconds.
rp-mapping-change change-value	Specifies the minimum interval for sending trap messages about the Rendezvous Point (RP)-mapping change.	The value is an integer that ranges from 0 to 65535, in seconds. The default value is 65535 seconds.
all	Specifies to undo all the minimum intervals for sending trap messages.	-

Views

Multicast MIB view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mcast-base	write

Usage Guidelines

Usage Scenario

The pim mib-notification interval command sets the interval for sending trap messages. When an event occurs, if the period since the last time for sending the trap message is shorter than the configured interval, the system does not send any trap message.

If the default interval is 0, it indicates that a trap message is sent immediately after an event occurs.
If the default interval is 65535, it indicates that no trap message is sent after an event occurs. Then run this command to adjust the interval to a smaller value so that a trap message can be sent after an event occurs.

Example

# Set the interval for PIM to send trap messages about invalid Join/Prune messages.

<HUAWEI> system-view
[~HUAWEI] multicast mib
[*HUAWEI-multicast-mib] pim mib-notification interval invalid-join-prune 50