multicast-nat inbound enable

Function

The multicast-nat inbound enable command enables multicast NAT on an inbound interface of multicast streams.

The undo multicast-nat inbound enable command disables multicast NAT on an inbound interface of multicast streams.

By default, multicast NAT is disabled on interfaces.

This command is supported only on the NetEngine 8000 F1A.

Format

multicast-nat inbound enable

undo multicast-nat inbound enable

Parameters

None

Views

100GE interface view, 10GE interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE interface view, GE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

Before translating an input multicast stream into output multicast streams with different characteristics (source IP address, destination IP address, and destination port number), you must run the multicast-nat enable command to enable multicast NAT globally. Additionally, you must run the multicast-nat inbound enable command to enable multicast NAT on an inbound interface of multicast streams.

Prerequisites

Multicast NAT has been globally enabled using the multicast-nat enable command.

Precautions

This command is supported only in the admin VS.
The interface must work in Layer 3 mode, that is, the portswitch command cannot be run on the interface.
The interface cannot be an Eth-Trunk member interface.

Example

# Enable multicast NAT on the inbound interface GE 0/1/1.

<HUAWEI> system-view
[~HUAWEI] multicast-nat enable
[*HUAWEI] interface GigabitEthernet 0/1/1
[*HUAWEI-GigabitEthernet0/1/1] multicast-nat inbound enable