nat alarm server-map disable
Function
The nat alarm server-map disable command disables the log and alarm functions for the server-map table.
The undo nat alarm server-map disable command restores the default configuration.
By default, the log and alarm functions are enabled for the server-map table.
This command is supported only on the NetEngine 8000 F1A.
Parameters
| Parameter | Description | Value |
|---|---|---|
| log |
Indicates the log function. This parameter indicates whether a device generates a log message after the number of server-map entries exceeds a specified log threshold. or after the number of server-map entries falls below 80% of a specified log threshold. |
- |
| trap |
Indicates the alarm function. This parameter indicates whether a device generates an alarm message after the number of server-map entries exceeds a specified alarm threshold, or after the number of server-map entries falls below 80% of a specified alarm threshold. |
- |
Usage Guidelines
Usage Scenario
The log and alarm functions are enabled by default. To disable the functions, run the nat alarm server-map disable command.
Precautions
The nat alarm server-map disable command is used together with the nat alarm server-map threshold command. The nat alarm server-map threshold command sets the log and alarm thresholds for the number of server-map entries.
If the nat alarm server-map threshold command is not run, the default log and alarm thresholds are 80% of the total number of server-map entries.In VS mode, this command is supported only by the admin VS.