pe-vid ce-vid (NQA test flow view)

Function

The pe-vid ce-vid command sets the inner and outer VLAN IDs carried in Ethernet service activation test packets.

The undo pe-vid command deletes VLAN IDs.

By default, no VLAN IDs are set.

Format

pe-vid pe-vid ce-vid ce-vid [ ce-vid-end ]

undo pe-vid

Parameters

Parameter	Description	Value
pe-vid	Specifies the outer VLAN ID carried in Ethernet service activation test packets.	The value is an integer ranging from 1 to 4094.
ce-vid ce-vid	Specifies the inner VLAN ID or the start VLAN ID in a range of VLAN IDs carried in Ethernet service activation test packets.	The value is an integer ranging from 1 to 4094.
ce-vid-end	Specifies the end VLAN ID in a range of inner VLAN IDs carried in Ethernet service activation test packets.	The value is an integer ranging from 1 to 4094.

Parameter

Description

Value

pe-vid

Specifies the outer VLAN ID carried in Ethernet service activation test packets.

The value is an integer ranging from 1 to 4094.

ce-vid ce-vid

Specifies the inner VLAN ID or the start VLAN ID in a range of VLAN IDs carried in Ethernet service activation test packets.

The value is an integer ranging from 1 to 4094.

ce-vid-end

Specifies the end VLAN ID in a range of inner VLAN IDs carried in Ethernet service activation test packets.

The value is an integer ranging from 1 to 4094.

Views

NQA test flow view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
sla	write

Usage Guidelines

Usage Scenario

To set the inner and outer VLAN IDs carried in Ethernet service activation test packets, run the pe-vid ce-vid command. The reflector can loop packets carrying the specified VLAN IDs.

NOTE:

For the same test flow, a range can be specified only in one of the traffic-type, vlan, pe-vid, udp destination-port, and udp source-port commands. In addition, the difference between the start and end values cannot be more than 127, and the end value must be greater than the start value.

Example

# Set the inner VLAN ID to 10 and outer VLAN ID to 20 in Ethernet service activation test packets.

<HUAWEI> system-view
[~HUAWEI] nqa test-flow 1
[*HUAWEI-nqa-testflow-1] pe-vid 20 ce-vid 10