ospfv3 flush-source-trace block

Function

The ospfv3 flush-source-trace block command disables OSPFv3 flush LSA source tracing on an interface.

The undo ospfv3 flush-source-trace block command enables OSPFv3 flush LSA source tracing on an interface.

By default, OSPFv3 flush LSA source tracing is enabled on all interfaces.

Format

ospfv3 flush-source-trace block [ instance instance-id ]

undo ospfv3 flush-source-trace block [ instance instance-id ]

Parameters

Parameter	Description	Value
instance instance-id	Specifies an interface instance ID.	The value is an integer ranging from 0 to 255. The default value is 0.

Parameter

Description

Value

instance instance-id

Specifies an interface instance ID.

The value is an integer ranging from 0 to 255. The default value is 0.

Views

100GE interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk interface view, FlexE interface view, GE optical interface view, GE electrical interface view, Global VE sub-interface view, Tunnel interface view, VBDIF interface view, VE sub-interface view, VLANIF interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
ospf	write

Usage Guidelines

Usage Scenario

By default, the OSPFv3 flush LSA source tracing function is enabled on all interfaces of a specified OSPFv3 process. To disable this function on an interface, run the ospfv3 flush-source-trace block command.

Prerequisites

OSPFv3 has been enabled using the ospfv3 area command in the interface view.

Example

# Disable OSPFv3 flush LSA source tracing on a specified interface.

<HUAWEI> system-view
[~HUAWEI] ospfv3 1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface GigabitEthernet 0/1/1
[*HUAWEI-GigabitEthernet0/1/1] ipv6 enable
[*HUAWEI-GigabitEthernet0/1/1] ospfv3 1 area 0
[*HUAWEI-GigabitEthernet0/1/1] ospfv3 flush-source-trace block