pads

Function

The pads disable command disables the protocol auxiliary diagnosis system (PADS).

The undo pads disable command enables the PADS.

The pads switch command enables or disables a specific function in the protocol-aided diagnosis system.

The undo pads switch command enables or disables a specific function in the protocol-aided diagnosis system.

By default, The protocol-assisted diagnostic system is enable, the status of functions in the protocol-aided diagnosis system is determined by the pads disable command.

Format

pads disable

pads switch appName enable

pads switch appName disable

undo pads disable

undo pads switch appName enable

undo pads switch appName disable

Parameters

Parameter	Description	Value
switch appName	Modual name.	The value is an enumerated type. You can select a value according to the prompt information after entering a question mark (?).
enable	Enable protocol aided diagnosis system.	-
disable	Disable protocol aided diagnosis system.	-

Parameter

Description

Value

switch appName

Modual name.

The value is an enumerated type. You can select a value according to the prompt information after entering a question mark (?).

enable

Enable protocol aided diagnosis system.

disable

Disable protocol aided diagnosis system.

Views

System view

Default Level

3: Management level

Task Name and Operations

Task Name	Operations
diagnose	write

Usage Guidelines

Usage Scenario

The protocol-aided diagnosis system helps diagnose protocol problems such as OSPF route flapping and IP address conflict.

The pads disable command controls the status of the entire protocol-aided diagnosis system, and the pads switch command controls a specific function's status in the protocol-aided diagnosis system.

If the pads switch command is not run, the status of functions in the protocol-aided diagnosis system is determined by the pads disable command. If the pads switch command is run, the status of a specific function in the protocol-aided diagnosis system is determined by the pads switch command no matter the status of the entire protocol-aided diagnosis system is enabled or disabled.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Enable the memory leak diagnosis in the protocol-aided diagnosis system.

<HUAWEI> system-view
[~HUAWEI] pads switch memory-leak enable

# Enable the EUM diagnosis in the protocol-aided diagnosis system.

<HUAWEI> system-view
[~HUAWEI] pads switch eum-health enable

# Disable the PADS.

<HUAWEI> system-view
[~HUAWEI] pads disable

# Enable the EVPN diagnosis in the protocol-aided diagnosis system.

<HUAWEI> system-view
[~HUAWEI] pads switch evpn-health enable

# Enable the ARP diagnosis in the protocol-aided diagnosis system.

<HUAWEI> system-view
[~HUAWEI] pads switch arp-learning enable