pbb service-type

Function

The pbb service-type p2p command configures P2P as the PBB VPLS service type.

The undo pbb service-type command restores the default configuration.

By default, no PBB VPLS service type is configured.

Format

pbb service-type p2p

undo pbb service-type

undo pbb service-type p2p

Parameters

Parameter	Description	Value
p2p	Configures P2P as the PBB VPLS service type.	-

Parameter

Description

Value

p2p

Configures P2P as the PBB VPLS service type.

Views

VSI--PBBENABLE view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
l2vpn	write

Usage Guidelines

Usage Scenario

After enabling an I-VSI, perform the following configurations for the I-VSI to take effect:

Run the pbb service-type p2p command to configure the PBB VPLS service type.
Run the pbb i-tag command to configure the I-tag.
Run the pbb backbone-source-mac command to configure the B-SMAC address.
Run the pbb backbone-destination-mac command to configure the B-DMAC address.

Prerequisites

An I-VSI has been enabled using the pbb i-vsi enable command.

Configuration Impact

If an I-VSI is bound to a B-VSI, you must remove the binding before running the undo pbb service-type command.

Precautions

The service type can be configured only in I-VSIs and can only be P2P in PBB VPLS currently. This means that an I-VSI can be bound only to one AC interface. If m CEs connecting to a local PE need to communicate with m CEs connecting to n peer PEs, m x n I-VSIs must be enabled.

Example

# Configure P2P as the PBB VPLS service type.

<HUAWEI> system-view
[~HUAWEI] mpls
[*HUAWEI-mpls] quit
[*HUAWEI] mpls l2vpn
[*HUAWEI-l2vpn] quit
[*HUAWEI] vsi vsi1
[*HUAWEI-vsi-vsi1] pwsignal ldp
[*HUAWEI-vsi-vsi1-ldp] vsi-id 1
[*HUAWEI-vsi-vsi1-ldp] quit
[*HUAWEI-vsi-vsi1] pbb i-vsi enable
[*HUAWEI-vsi-vsi1] pbb service-type p2p