peer (BGP view)

Format

peer ipv4-address { listen-only | connect-only }

undo peer ipv4-address { listen-only | connect-only }

Parameters

Parameter	Description	Value
ipv4-address	Specifies the IPv4 address of a peer.	The value is in dotted decimal notation.

Parameter

Description

Value

ipv4-address

Specifies the IPv4 address of a peer.

The value is in dotted decimal notation.

Views

BGP view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

The peer listen-only command is used to configure a peer to only listen to connection requests and not to initiatively send connection requests.

The peer connect-only command is used to configure a peer to send connection requests but rejects connection requests.

Configuration Impact

If the peer listen-only command is run multiple times, the latest configuration overwrites the previous one.

After being configured with the peer listen-only command, a peer does not initiate any connection request.

Precautions

The peer listen-only command can be run at only one end of a peer relationship. If this command is run at both ends of a peer relationship, the ends fail to establish a connection.

The peer connect-only command or the peer listen-only command cannot be run on two devices that will establish a peer relationship. Otherwise, no peer relationship can be established between the two devices.

Example

# Enable peer to send connection requests but rejects connection requests.

<HUAWEI> system-view
[~HUAWEI] bgp 100
[*HUAWEI-bgp] peer 10.1.1.1 as-number 200
[*HUAWEI-bgp] peer 10.1.1.1 connect-only