port-access-limit

Function

The port-access-limit command limits the number of access users on a physical port.

The undo port-access-limit command restores the default setting.

By default, the maximum number of users that access a physical port is not configured on an interface.

This command is supported only on the NetEngine 8000 F1A.

port-access-limit number

undo port-access-limit

Parameter	Description	Value
number	Specifies the maximum number of access users on the physical port.	The value is an integer ranging from 0 to 65536.

Parameter

Description

Value

number

Specifies the maximum number of access users on the physical port.

The value is an integer ranging from 0 to 65536.

Interface view

2: Configuration level

Task Name	Operations
bras-control	write

Usage Scenario

The port-access-limit command must be run on the master interface.

Precautions

In VS mode, this command is supported only by the admin VS.

# Set the maximum number of access users on GE0/1/1 to 200.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/1
[~HUAWEI-GigabitEthernet0/1/1] port-access-limit 200