ptp notslave disable

Function

The ptp notslave disable command sets the notslave attribute to FALSE on an interface.

The undo ptp notslave disable command restores the default notslave attribute value of TRUE on an interface.

The default notslave attribute is TRUE.

By default, the notslave attribute is TRUE.

Format

ptp notslave disable

undo ptp notslave disable

Parameters

None

Views

100GE interface view, 10G LAN interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE interface view, FlexE-100G interface view, FlexE-400G interface view, FlexE-50G interface view, GE optical interface view, GE electrical interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
clksync	write

Usage Guidelines

Usage Scenario

ITUT G.8275.1 defines the notslave attribute of an interface. To configure the notslave attribute, run the ptp notslave disable command. If the notslave attribute is set to TRUE, the PTP interface cannot enter the slave state. If the notslave attribute is set to FALSE, the PTP interface can enter the slave state.

This command applies only to G.8275.1 and CU-106.

Prerequisites

The ptp profile g-8275-1 enable or ptp profile cu-106 enable command has been run.

In VS mode, this command is supported only by the admin VS.

Example

# Set the notslave attribute of the GE 0/1/0 interface to FALSE.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/0
[~HUAWEI-GigabitEthernet0/1/0] ptp notslave disable