ptp source-switch ptsf recover

Function

The ptp source-switch ptsf recover command restores the time source that signal recovers normal back to the trace source.

By default, no recovery operation is performed.

Format

ptp source-switch ptsf recover

Parameters

None

Views

100GE interface view, 10G LAN interface view, 25GE interface view, 400GE interface view, 40GE interface view, 50GE interface view, FlexE-100G interface view, FlexE-400G interface view, FlexE-50G interface view, GE optical interface view, GE electrical interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
clksync	write

Usage Guidelines

Usage Scenario

After the ptp source-switch ptsf enable command is used to enable ptsf time source switching, if the current time source is detected with offset hops(over 1.1us 3 seconds in a row) or Sync packets loss, the device will switch to other available time source. After the signal of the time source recovers normal, run the ptp source-switch ptsf recover command to restore the time source back to the trace source.

Example

# Manual switch the time source which restored from ptsf to tracking source.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/0
[~HUAWEI-GigabitEthernet0/1/0 ] ptp source-switch ptsf recover