reset access trigger user-table
Function
The reset access trigger user-table command deletes information about users whose access packets are limited on a board.
This command is supported only on the NetEngine 8000 F1A.
Parameters
| Parameter | Description | Value |
|---|---|---|
| interface interface-type |
Deletes detailed information about users on a specified interface. |
- |
| interface-number |
Specifies the number of an interface. |
- |
| mac-address mac-address |
Deletes detailed information about the user with a specified MAC address. |
The value is a 12-digit hexadecimal number, in the format of H-H-H. Each H is 4 digits. If an H contains fewer than 4 digits, the left-most digits are padded with zeros. For example, e0 is displayed as 00e0. |
| ip-address ip-address |
Deletes detailed information about the user with a specified IPv4 address. |
The value is in dotted decimal notation. |
| prefix prefix-address |
Deletes detailed information about the user with a specified IPv6 prefix. |
The value is a 32-bit hexadecimal number, in the format of X:X:X:X:X:X:X:X. |
| ipv6-address ipv6-address |
Deletes detailed information about the user with a specified IPv6 address. |
The value is a 32-bit hexadecimal number, in the format of X:X:X:X:X:X:X:X. |
| all |
Deletes information about users whose access packets are limited on all boards. |
- |
| slot slot-id |
Deletes information about users whose access packets are limited on the board in a specified slot. |
- |
Usage Guidelines
Usage Scenario
After the access trigger packet-limit command is run to configure a limit on the number of ARP/IP/IPv6/ND packets that can be sent to the main control board, you can run the reset access trigger user-table command to delete information about users whose access packets are limited.
Prerequisites
The access trigger packet-limit command has been run.
Precautions
In VS mode, this command is supported only by the admin VS.