The reset mpls te tunnel-interface tunnel command resets a TE tunnel interface and re-establishes a TE tunnel.
| Parameter | Description | Value |
|---|---|---|
| interface-type |
Specifies the interface type. |
- |
| interface-number |
Specifies the interface number. |
- |
| tunnel-name |
Specifies the P2MP TE tunnel name. |
The value is a string of 1 to 255 case-sensitive characters, spaces not supported. The tunnel name must be the same as that in the configuration file, case-sensitive and spaces not supported. For example, if a configuration file specifies the tunnel interface "interface Tunnel10", the tunnel-name parameter must specify the P2MP TE tunnel as "Tunnel10". Both "Tunnel10" and "Tunnel 10" are incorrect. |
Usage Scenario
The reset mpls te tunnel-interface tunnel command is used to allow a specified tunnel interface to re-establish an MPLS TE tunnel.
Configuration Impact
All CR-LSPs in a specified tunnel will be deleted and new CR-LSPs will be re-established.
If no explicit path is configured for a tunnel, resetting a tunnel causes a device to use existing link information to re-calculate a path. The calculate path may be different from the original path due to the delay in flooding bandwidth.