mpls te bandwidth (Tunnel interface view)

Function

The mpls te bandwidth command is used to configure the bandwidth constraint of an MPLS TE tunnel.

The undo mpls te bandwidth command is used to restore the default bandwidth constraint of an MPLS TE tunnel.

By default, the tunnel has no bandwidth constraints.

Format

mpls te bandwidth ctType ctValue

undo mpls te bandwidth all

undo mpls te bandwidth ctType [ ctValue ]

Parameters

Parameter	Description	Value
ctType	CT Type.	The values are ct0, ct1, ct2, ct3, ct4, ct5, ct6 and ct7.
ctValue	Bandwidth in CT.	The value is an integer ranging from 1 to 4000000000, in kbit/s.
all	All ct.	-

Parameter

Description

Value

ctType

CT Type.

The values are ct0, ct1, ct2, ct3, ct4, ct5, ct6 and ct7.

ctValue

Bandwidth in CT.

The value is an integer ranging from 1 to 4000000000, in kbit/s.

all

All ct.

Views

Tunnel interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mpls-te	write

Usage Guidelines

Usage Scenario

To make the tunnel up, you need to configure the tunnel bandwidth.

Precautions

The parameters cr1 to ct7 are only used in DS-TE scenarios.

Example

# Configure the bandwidth required for the corresponding TE tunnel on Tunnel 1. The CT0 bandwidth is 2000 Kbit/s.

<HUAWEI> system-view
[~HUAWEI] mpls
[*HUAWEI-mpls] mpls te
[*HUAWEI-mpls] interface tunnel1
[*HUAWEI-Tunnel1] tunnel-protocol mpls te
[*HUAWEI-Tunnel1] mpls te bandwidth ct0 2000