signaling vpws

Function

The signaling vpws command configures the VPWS signaling mode for all peers or peer groups.

The undo signaling vpws command restores the default signaling mode of all peers or peer groups.

By default, after the peer enable command is run in the L2VPN AD address family view, the BGP AD signaling mode is used.

Format

signaling vpws

undo signaling vpws

Parameters

None

Views

BGP-L2VPN-AD address family view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

In remote BGP VPWS connection scenarios, the VPWS signaling mode must be enabled in the L2VPN AD address family view for BGP peers to exchange VPWS routes. To configure the VPWS signaling mode for all peers or peer groups, run the signaling vpws command.

Prerequisites

A peer or peer group has been enabled using the peer enable command.

Precautions

The signaling mode configured using the peer signaling vpws command takes precedence over the signaling mode configured using the signaling vpws command. If no signaling mode is configured for a peer or peer group but the signaling vpws command has been run, the peer or peer group uses the VPWS signaling mode configured using the signaling vpws command.

Example

# Configure the BGP VPWS signaling mode for all peers or peer groups in the L2VPN AD address family view.

<HUAWEI> system-view
[~HUAWEI] bgp 100
[*HUAWEI-bgp] l2vpn-ad-family
[*HUAWEI-bgp-af-l2vpn-ad] signaling vpws