Specifies a DSCP value for the SSH packets sent by a server.
The value is an integer ranging from 0 to 63.
Views
System view
Default Level
3: Management level
Task Name and Operations
Task Name
Operations
ssh-server
write
Usage Guidelines
To change the priority of the SSH packets sent by a server, run the ssh server dscp command to change the DSCP value of the packets. A greater DSCP value indicates a higher priority.
The priority of this command is higher than that of the host-packet type dscp command. If a DSCP value is configured using this command, the configured value takes effect. If a DSCP value is configured using the host-packet type dscp command rather than this command, the value configured using the host-packet type dscp command takes effect. If no DSCP value is configured using the preceding commands, the default DSCP value is used.
When you run the undo ssh server dscp command:
If value is not specified, the DSCP field is restored to the default value.
If value is 48, the DSCP field is restored to the default value.
If value is set to a non-48 value, the value must be the same as value in the telnet server dscp command. Otherwise, the command execution fails.
The command only takes effect for IPv4 packets.
Example
# Set the DSCP value to 10 for the SSH packets sent by a server.