restart (NQA view)

Function

The restart command stops a running test instance and then restarts this test instance.

By default, the on-going test instance is not aborted manually.

Format
Parameters
Views
Default Level
Task Name and Operations
Usage Guidelines
Example

Format

restart

Parameters

None

Views

NQA view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
sla	write

Usage Guidelines

Usage Scenario

Running the restart command has the same function as running the following commands in sequence:

1.Run the stop command to stop running NQA test instances. The stop command stops only the running NQA test instances (test instances in the active state).

2.Run the start now command to start the NQA test instance immediately. For the same test instance, the start now command can be used again only after the previous configuration is complete.

To restart a test instance, you can use the restart command.

Configuration Impact

If a test instance is not complete, running the restart command causes incomplete test results.

Precautions

If a test instance is not started, running the restart command functions the same as running the start now command. Both commands start the test instance immediately.

Example

# Restart the test instance named user test.

<HUAWEI> system-view
[~HUAWEI] nqa test-instance user test
[*HUAWEI-nqa-user-test] test-type icmp
[*HUAWEI-nqa-user-test] destination-address ipv4 10.1.1.1
[*HUAWEI-nqa-user-test] restart