statistic enable (interface view)

Function

The statistic enable command enables IPv4 and IPv6 traffic statistics on the main interface.

The undo statistic enable command disables IPv4/IPv6 traffic statistics on the main interface.

By default, IPv4 and IPv6 traffic statistics on the main interface are disabled.

Format

statistic enable

undo statistic enable

Parameters

None

Views

100GE interface view, 10G LAN interface view, 10G WAN interface view, 25GE interface view, 40GE interface view, Eth-Trunk interface view, GE interface view, GE electrical interface view, Management interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
forwarding	write

Usage Guidelines

Usage Scenario

After a device is enabled to send IP statistics on a physical interface, the interface collects IPv4 and IPv6 traffic statistics separately and sends them to the NMS.

Implementation Procedure

Enable IP statistics on a physical interface.

Configuration Impact

After a device is enabled to send IP statistics on a physical interface, the device applies statistics resources for the interface.

After a device is disabled from sending IP statistics on a physical interface, the device releases statistics resources on the interface.

Precautions

After running the statistic enable (main interface view) command, you have to run the statistic mode forward command to allow the dual-stack traffic statistics collection function to take effect.

Example

# Enable the device to send IPv4 and IPv6 traffic statistics on GE 0/1/0 separately to the NMS.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet0/1/0
[~HUAWEI-GigabitEthernet0/1/0] statistic enable