mpls te bandwidth (Interface)

Function

The mpls te bandwidth command is used to set or modify the bandwidth of the BC on the link.

The undo mpls te bandwidth command is used to restore the default.

By default, no BC bandwidth is configured for a link.

Format

mpls te bandwidth bc0-bw-value

undo mpls te bandwidth

Parameters

Parameter	Description	Value
bc0-bw-value	Specifies the bandwidth value of BC0.	The value is an integer ranging from 0 to 4000000000, in kbit/s.

Parameter

Description

Value

bc0-bw-value

Specifies the bandwidth value of BC0.

The value is an integer ranging from 0 to 4000000000, in kbit/s.

Views

100ge sub-interface view, 100GE interface view, 10GE sub-interface view, 10GE interface view, 25GE sub-interface view, 25GE interface view, 400GE sub-interface view, 400GE interface view, 40GE sub-interface view, 40GE interface view, 50GE sub-interface view, 50GE interface view, Eth-Trunk sub-interface view, Eth-Trunk interface view, GE optical interface view, GE sub-interface view, GE electrical interface view, GMPLS-UNI interface view, Tunnel interface view, XGE sub-interface view, XGE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
mpls-te	write

Usage Guidelines

Usage Scenario

Use the mpls te bandwidth command to set or modify the bandwidth of the BC on the link.

Example

# Set the link BC0 bandwidth to 1000 Kbit/s.

<HUAWEI> system-view
[~HUAWEI] interface GigabitEthernet 0/1/0
[~HUAWEI-GigabitEthernet0/1/0] mpls te bandwidth 1000