timer wait-for-eor (BGP-VPN-Target address family view)

Function

The timer wait-for-eor command sets the maximum time for the BGP-VPN-Target address family to wait for the End-Of-RIB flag.

The undo timer wait-for-eor command restores the default setting.

By default, the period is 180s.

Format

timer wait-for-eor eor-time

undo timer wait-for-eor

Parameters

Parameter	Description	Value
eor-time	Specifies the maximum time to wait for the end flag of RIB route sending.	The value is an integer ranging from 3 to 3000, in seconds.

Parameter

Description

Value

eor-time

Specifies the maximum time to wait for the end flag of RIB route sending.

The value is an integer ranging from 3 to 3000, in seconds.

Views

BGP-VPN-target address family view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

In a VPN ORF scenario, if a BGP session is being established or re-established, but the local device fails to receive an End-of-RIB message from a BGP peer in the BGP-VPN-Target address family within the period configured using the timer wait-for-eor command, the device does not advertise VPNv4 or VPNv6 routes during this period. If the local device receives such a message within the period or the period expires but the local device fails to receive such a message, the local device advertises VPNv4 and VPNv6 routes immediately.

Example

# Set the period during which a device waits for an End-of-RIB message from a BGP peer in the BGP-VPN-Target address family to 100s.

<HUAWEI> system-view
[~HUAWEI] bgp 100
[*HUAWEI-bgp] ipv4-family vpn-target
[*HUAWEI-af-vpn-target] timer wait-for-eor 100