sendpacket passroute (Trace test instance)

Function

The sendpacket passroute command configures an NQA trace test instance to send packets without searching the routing table.

The undo sendpacket passroute command enables an NQA trace test instance to send packets based on the routing table.

By default, an NQA test instance sends packets with searching the routing table.

Format

sendpacket passroute

undo sendpacket passroute

Parameters

None

Views

NQA view

Default Level

2: Configuration level

Task Name and Operations

Task Name Operations
sla write

Usage Guidelines

Usage Scenario

To configure an NQA test instance to send packets without searching the routing table, run the sendpacket passroute command.

The sendpacket passroute command is applicable to the following scenarios:

No source IP address is set.

  • If no outbound interface is configured for an NQA test instance, after the sendpacket passroute command is run, the source IP address of packets to be sent in the test is obtained using an internal algorithm.
  • If an outbound interface is configured for an NQA test instance, after the sendpacket passroute command is run, the IP address of the outbound interface is used as the source IP address of packets to be sent in the test.

    A source IP address is set.
  • If no outbound interface is configured for an NQA test instance, after the sendpacket passroute command is run, the specified source IP address is used as the source IP address of packets to be sent in the test.
  • If an outbound interface is configured for an NQA test instance, after the sendpacket passroute command is run, the specified source IP address is used as the source IP address of packets to be sent in the test.

Precautions

If parameters need to be changed during the running of the test instance, the system prompts you whether to terminate the test instance. Press "Y" or "N" as required.

  • If you press "Y", the test instance is terminated and parameters changed. The settings take effect after being committed. To restart the test instance, run the start command.
  • If you press "N", the test instance keeps running, and the parameters fail to be modified.

Example

# Configure the test instance named user test to send packets without searching the routing table.
<HUAWEI> system-view
[~HUAWEI] nqa test-instance user test
[*HUAWEI-nqa-user-test] test-type trace
[*HUAWEI-nqa-user-test] sendpacket passroute
Parent Topic: NQA Configuration Commands
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >