trap-threshold bip8-sd

Function

The trap-threshold bip8-sd command configures an alarm threshold for BIP8 SD errors occurring within a certain period.

The undo trap-threshold bip8-sd command restores the default alarm threshold for BIP8 SD errors.

By default, the alarm threshold for BIP8 SD errors is 6.

Format

trap-threshold bip8-sd bip8-sd

undo trap-threshold bip8-sd

Parameters

Parameter	Description	Value
bip8-sd bip8-sd	Specifies an alarm threshold for BIP8 SD errors in the format of 10^-n, where n is specified by bip8-sd.	The value is an integer ranging from 6 to 9. The default value is 6. Therefore, the alarm threshold for BIP8 SD errors is 10^-6.

Parameter

Description

Value

bip8-sd bip8-sd

Specifies an alarm threshold for BIP8 SD errors in the format of 10^-n, where n is specified by bip8-sd.

The value is an integer ranging from 6 to 9. The default value is 6. Therefore, the alarm threshold for BIP8 SD errors is 10^-6.

Views

100GE interface view, 40GE interface view, 50GE interface view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
device-mgr	write

Usage Guidelines

Usage Scenario

When the number of BIP8 SD errors occurring within a certain period exceeds the alarm threshold, the system generates an alarm and sends it to the NMS. When the number of BIP8 SD errors occurring within the period falls below an alarm clearance threshold, the system sends a message about alarm clearance to the NMS. The alarm clearance threshold is a magnitude lower than the alarm threshold for BIP8 SD errors. You can run the snmp-agent trap enable port command to enable the bip8-sd alarm function on an interface.

Precautions

The bip8-sd alarm function applies only to the 40GE/50GE/100GE interface.

Example

# Set the alarm threshold for BIP8 SD errors to 8 on the 100GE interface 1/0/0.

<HUAWEI> system-view
[~HUAWEI] interface 100GE0/1/0
[~HUAWEI-100GE0/1/0] trap-threshold bip8-sd 8