evpn mpls routing-enable

Function

The evpn mpls routing-enable command enables EVPN to generate and advertise IP prefix routes and IRB routes.

The undo evpn mpls routing-enable command restores the default configuration.

By default, EVPN is not enabled to generate and advertise IP prefix routes or IRB routes.

Format

evpn mpls routing-enable

undo evpn mpls routing-enable

Parameters

None

Views

VPN instance IPv4 address family view, VPN instance IPv6 address family view, VPN instance view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
l3vpn	write

Usage Guidelines

Usage Scenario

In an EVPN L3VPN scenario, if MPLS or SR-MPLS tunnels are used as public network tunnels (including interworking scenarios), run the evpn mpls routing-enable command to enable EVPN to generate and advertise IP prefix routes and IRB routes so that the local device can advertise IP prefix routes and IRB routes to EVPN peers. If non-MPLS tunnels are used on the public network, you do not need to run this command.

Example

# Enable EVPN to generate and advertise IP prefix routes and IRB routes.

<HUAWEI> system-view
[~HUAWEI] ip vpn-instance vpn1
[*HUAWEI-vpn-instance-vpn1] ipv4-family
[*HUAWEI-vpn-instance-vpn1-af-ipv4] route-distinguisher 100:1
[*HUAWEI-vpn-instance-vpn1-af-ipv4] evpn mpls routing-enable