The debugging packet filter l3 ipv6 command sets the filter condition for tracing layer 3 ipv6 protocol packets.
The undo debugging packet filter l3 ipv6 command cancels the filter condition for tracing layer 3 ipv6 protocol packets.
By default, all protocol packets are displayed after the protocol packet tracking function is enabled.
Usage Scenario
When the debugging information about layer 3 ipv6 protocol packets needs to be output on a terminal, the debugging packet filter l3 ipv6 command sets the filter condition for tracing the specified
protocol packets. The debugging information about the protocol packets that meets the filter condition is not output on the terminal.
Follow-up Procedure
After the filter condition for tracing protocol packets is set, run the display debugging packet all command to view the debugging information about the protocol packets on the terminal.
Precautions
In VS mode, this command is supported only by the admin VS.