Determining the Installation Position of the Cabinets

Positioning the cabinet.
1. Attach the plumb line to the cable rack that is vertical to the front of the cabinet. Use the marker to mark the point of the plumb on the ground.
2. Follow the same procedure to mark the second point, and draw the baseline by using the powder marker.
  Figure 1 Positioning the cabinet
  
  The method for positioning the cabinet described in this document is only for reference. Follow the engineering drawing to position the cabinet in the actual installation.
Determining installation holes for the cabinet.
Figure 2 Determining installation holes for the cabinet

The spacing between the rear door of the front access cabinet and the wall or any other obstacles should be no less than 100 mm.
Confirming the position of the drill holes.
1. Lay out the templates side by side and ensure that there is 600 mm between the center lines of two adjacent templates.
2. Use a marker to mark installation holes on the concrete floor.
  Figure 3 Confirming the position of the drill holes
  
  Position the template so that the semicircular gap indicates the front of the cabinet.
  
  After marking the reference lines, check the hole positions with a ruler.