ARP/4/ARP_SEC_SPEED_LIMIT

Message

ARP/4/ARP_SEC_SPEED_LIMIT: Packet speed exceeded the configured speed limit. (IfIndex=[IfIndex], SuppressValue=[SupValue], CurrentValue=[CurValue], SuppressType=[SupType], SourceIP=[SrcIp], DestinationIP=[DstIp], VpnInstance name=[VpnName])

Description

The transmit rate of ARP packets exceeded the configured rate limit.

Parameters

Parameter Name	Parameter Meaning
IfIndex	Interface index.
SupValue	Rate limit of ARP packets or ARP Miss messages.
CurValue	Type of packets that are suppressed: ARP packets or ARP Miss messages.
SupType	Type of packets that are suppressed: ARP packets or ARP Miss messages.
SrcIp	Source IP addresses of ARP packets or ARP Miss messages.
DstIp	Destination IP addresses of ARP packets or ARP Miss messages.
VpnName	VPN instances that ARP packets or ARP Miss messages belong to.

Possible Causes

Cause 1: The transmit rate of ARP packets exceeded the configured rate limit.

Cause 2: The transmit rate of ARP Miss messages exceeded the configured rate limit.

Procedure

1. Run the display arp speed-limit command to check the configured rate limit of ARP packets.

2. Run the arp speed-limit destination-ip maximum maximum slot slot-id command to reset the rate limit of ARP packets. The value must be greater than the value obtained in Step 1 but less than 65536. Then, check whether the trap is cleared.

If the trap is cleared, go to Step 4.
If the trap persists, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.

4. End.