PIM/4/HW_DR_ELECTION_NORMAL

Message

PIM/4/HW_DR_ELECTION_NORMAL: The interface was elected as a DR. (IfIndex=[IfIndex], IfIPverion=[IfIPverion], IfAddrType=[IfAddrType], Addr=[Addr], IfName=[PimInterfaceName], PimInstanceID=[PimInstanceID], PimInstanceName=[PimInstanceName])

Description

The interface is elected as a DR interface.

Parameters

Parameter Name	Parameter Meaning
IfIndex	Interface index
IfIPverion	IP version of the interface
IfAddrType	Interface address type
Addr	Interface address
PimInterfaceName	Interface name
PimInstanceID	VPN instance ID
PimInstanceName	VPN instance name

Possible Causes

Cause1: The PIM interface received a new Hello packet and had a higher DR priority or IP address than other interfaces on the shared network segment.

Cause2: After a PIM interface went Up, the PIM interface did not receive Hello packets after the interval between Hello packets expired.

Procedure

1. Check whether the interface can be a DR interface.

If the interface can be a DR interface, go to Step 4.
If the interface cannot be a DR interface, go to Step 2.

2. Configure a lower priority or a smaller IP address for the interface.

If the log is cleared, go to Step 4.
If the log is not cleared, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.

4. End.