NVO3/2/IPv4VxlanTunnelDown_active

Message

NVO3/2/IPv4VxlanTunnelDown_active: The IPv4 vxlan tunnel status changes. (SourceIpAddress=[SrcIpAddr], DestinationIpAddress=[DstIpAddr], TunnelStatus=[TnlStatus])

In VS mode, this log is supported only by the admin VS.

Description

The IPv4 VXLAN tunnel status changed.

Parameters

Parameter Name	Parameter Meaning
SrcIpAddr	Source VTEP address of an IPv4 VXLAN tunnel.
DstIpAddr	Remote VTEP address of an IPv4 VXLAN tunnel.
TnlStatus	IPv4 VXLAN tunnel status.

Possible Causes

The IPv4 VXLAN tunnel went Down.

Procedure

1. Run the display ip routing-table command to check whether the source and destination IPv4 addresses of the IPv4 VXLAN tunnel are reachable.

If yes, go to Step 3.
If no, go to Step 2.

2. Configure a static or dynamic route so that the source and destination IPv4 addresses of the IPv4 VXLAN tunnel are reachable. Then run the display vxlan tunnel command to check whether the IPv4 VXLAN tunnel goes up.

If yes, go to Step 4.
If no, go to Step 3.

3. Collect log and configuration information, and contact Huawei technical support personnel.

4. End.