MSTP/4/MSTPLOG_PROPORT_LOOP_GUARDED

Message

MSTP/4/MSTPLOG_PROPORT_LOOP_GUARDED: The loop protection port in the instance of the MSTP process did not receive BPDU packets within prescriptive time. (ProcessID=[ProcessID], InstanceID=[InstanceID], PortID=[PortID], IfIndex=[IfIndex], PortName=[PortName], PwName=[PwName])

Description

The port that has loop protection enabled did not receive BPDUs within the specified time.

Parameters

Parameter Name	Parameter Meaning
ProcessID	Indicates the ID of an MSTP process.
InstanceID	Indicates the instance ID.
PortID	Indicates the port ID.
IfIndex	Indicates the interface index.
PortName	Indicates the port name.
PwName	Indicates the PW name.

Possible Causes

Cause 1: The spanning tree function was disabled on the peer device.

Cause 2: The links connected to the peer were congested.

Procedure

Cause 1: The spanning tree function was disabled on the peer device.

1. Run the display stp [ process ] [ instance instance-id ] [ interface interface-type interface-number | slot slot-id | vsi vsi-name pw ] [ brief ] command to check whether STP is disabled on the interfaces that are directly connected.

If STP is disabled on the interfaces that are directly connected, go to Step 2.
If STP is enabled on the interfaces that are directly connected, go to Step 3.

2. Run the stp enable command in the interface view to enable STP. Then, check whether the alarm is cleared. If the alarm persists, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.

Cause 2: The links connected to the peer were congested.

1. Check whether the link is congested between the local device and the neighbor device.

If the link is congested, go to Step 2.
If the link is not congested, go to Step 3.

2. Repair the physical link and then check whether the alarm is cleared. If the alarm persists, go to Step 3.

3. Collect log information and configuration information, and then contact technical support personnel.