OSPFV3/6/OSPFV3_INTF_FLAPPING_SUPPRESS_STATUS

Message

OSPFV3/6/OSPFV3_INTF_FLAPPING_SUPPRESS_STATUS: The status of peer flapping suppress is changed.(ProcessId=[ProcessId], RouterId=[RouterId], AreaId=[AreaId], ifName=[ifName], SuppressStatus=[SuppressStatus], SuppressReason=[SuppressReason])

Description

The status of OSPFv3 neighbor relationship flapping suppression changed on the local interface.

Parameters

Parameter Name	Parameter Meaning
ProcessId	Process ID
RouterId	Router ID
AreaId	Area ID
ifName	Interface name
SuppressStatus	Suppression status
SuppressReason	Suppression causes are as follows: 1: The interval between two successive neighbor status changes from Full to a non-Full state was longer than the resume interval. 2: A configuration was changed. For example, the OSPFv3 process was reset. 3: An interface was forced to exit from OSPFv3 neighbor relationship flapping suppression using the reset ospfv3 suppress-flapping peer command. 4: The OSPFv3 neighbor relationship flapped frequently. 5: OSPFv3 neighbor relationship flapping suppression exited from Hold-down mode and began to work in Hold-max-cost mode.

Possible Causes

OSPFv3 neighbor relationship flapping suppression started on the local interface, or the interface exited from the suppression.

Procedure

1. Check whether frequent interface flapping occurs.

If frequent interface flapping occurs, this trap message is informational only and no action is required.
If no frequent interface flapping occurs, go to Step 2.

2. Run the reset ospfv3 process-id suppress-flapping peer [ ] [ notify-peer ] command to force the interface to exit from OSPFv3 neighbor relationship flapping suppression.

3. End.