DRIVER/4/PICINIT

Cause of the initialization failure. The possible causes are as follows:

• The FPGA self-check fails.
• Failed to create the module memory.
• Failed to reset the clock FPGA.
• The clock module fails to be initialized.
• The power-on reset fails.
• Initialization phase 1 fails.
• The pcie-switch module fails to be initialized.
• The PCIe fails to be initialized.
• Initialization phase 2 fails.
• QoS initialization failed.
• Failed to initialize the port.
• Interlaken initialization failed.
• Failed to initialize the interrupt.
• Failed to check the 38.8 MHz clock status.
• Failed to check the 155.52 MHz clock status.
• Failed to check the 156.25 MHz clock status.
• Failed to check the 175M clock status.
• The PLL failed to be locked.
• Failed to lock the phase discrimination.
• Failed to disable Interlaken.
• The SPI fails to be disabled.
• The interrupt fails to be disabled.
• The framer fails to be reset.
• Framer self-check fails.
• Failed to disable the optical module on the port.
• The framer fails to be initialized.
• The SPI fails to be initialized.
• Failed to open Interlaken.
• The SPI fails to be enabled.
• Failed to set the 8 kHz clock.
• JTAG loading fails.
• Failed to write the FPGA register.
• The LED board fails to be initialized.
• The CDR module fails to be initialized.
• The gearbox module fails to be initialized.
• Failed to initialize the heartbeat.
• The clock detection fails.