PIM/4/PIM_VRF_ROUTE_THRESHOLD_active

Message

PIM/4/PIM_VRF_ROUTE_THRESHOLD_active: The number of existed routing entries exceeded the vpn upper threshold. (LimitType=[LimitType], AddressFamily=[AddressFamily], VpnName=[VpnName], CurrentCount=[CurrentCount], LimitCount=[LimitCount], ThresholdCount=[ThresholdCount])

Description

The number of PIM-SM entries in the VPN instance reached or exceeded the configured log trigger threshold.

Parameters

Parameter Name	Parameter Meaning
LimitType	Type of entry for which an entry number limit takes effect, which is one of the followings: PIM-SM (*, G) entry PIM-SM (S, G) entry
AddressFamily	Address family.
VpnName	Name of a VPN instance.
CurrentCount	Number of PIM-SM entries in the VPN instance.
LimitCount	Limit on the number of PIM-SM entries.
ThresholdCount	Log trigger threshold for the number of PIM-SM entries.

Possible Causes

Cause 1: Entry create
Cause 2: Configuration change

Procedure

Cause 1: Entry create
1. Check whether AddressFamily is IPv4.If AddressFamily is IPv4, the log is triggered in the IPv4 address family of a VPN instance. Perform the following operations:
- a. Run the display multicast pim sm statistics command to check whether the log trigger threshold or the number limit is low.
- If the log trigger threshold or the number limit is low, go to Step b.
- If the log trigger threshold or the number limit is not low, go to Step c.
- b. Run the multicast limit pim sm command to adjust the log trigger threshold or the number limit. Then check whether the fault is rectified.
- If the fault is rectified, go to Step d.
- If the fault is not rectified, go to Step c.
- c. Collect log information and configuration information, and then contact technical support personnel.
- d. End.
2. Check whether AddressFamily is IPv6. If AddressFamily is IPv6, the log is triggered in the IPv6 address family of a VPN instance. Perform the following operations:
- a. Run the display multicast ipv6 pim sm statistics command to check whether the log trigger threshold or the number limit is low.
- If the log trigger threshold or the number limit is low, go to Step b.
- If the log trigger threshold or the number limit is not low, go to Step c.
- b. Run the multicast ipv6 limit pim sm command to adjust the log trigger threshold or the number limit. Then check whether the fault is rectified.
- If the fault is rectified, go to Step d.
- If the fault is not rectified, go to Step c.
- c. Collect log information and configuration information, and then contact technical support personnel.
- d. End.
Cause 2: Configuration change
The same as Cause 1.