TRUNK/2/TRUNK_MEM_LINKDOWN: The link status of the trunk member interface turned to DOWN.(ifIndex=[ifIndex], ifAdminStatus=[ifAdminStatus], ifOperStatus=[ifOperStatus], ifDescr=[ifDescr], hwIFExtPhyStatus=[hwIFExtPhyStatus], hwIFExtMemberOf=[hwIFExtMemberOf])
| Parameter Name | Parameter Meaning |
|---|---|
|
ifIndex |
Index of a trunk member interface |
|
ifAdminStatus |
Administration status of a trunk member interface |
|
ifOperStatus |
Operating status of a trunk member interface |
|
ifDescr |
Name of a trunk member interface |
|
hwIFExtPhyStatus |
Physical status of a trunk member interface |
|
hwIFExtMemberOf |
Name of the trunk interface to which the member interface belongs |
Cause 1: The interface was shut down, and its inserted physical link was disconnected. Cause 2: The link-layer protocol status of the interface became Down.
1. Run the display this command in the interface view to check whether the trunk member interface is shut down.
2. Run the undo shutdown command in the interface view to enable the interface and then check whether the alarm is cleared. If the alarm persists, go to Step 3.
3. Check whether the physical connection of the interface is proper (for example, whether the network cable is properly connected and optical module is properly inserted).
4. Correctly connect the physical link and check whether the alarm is cleared. If the alarm persists, go to Step 5.
5. Collect alarm information and configuration information, and then contact technical support personnel.
1. Run the display this command in the interface view to check whether the trunk member interface is shut down.
2. Run the undo shutdown command in the interface view to enable the interface and then check whether the alarm is cleared. If the alarm persists, go to Step 3.
3. Troubleshoot the Down fault of the link-layer protocol. If the link-layer protocol still cannot go Up, go to Step 4.
4. Collect alarm information and configuration information, and then contact technical support personnel.