DEFEND/4/hwBaseSecApplicationL2LoopOcurred_clear

Message

DEFEND/4/hwBaseSecApplicationL2LoopOcurred_clear: L2 loop detect cleared, the loop on an interface has cleared. (ChassisID=[ChassisID], SlotID=[SlotID],Interface Name=[IfName], VlanID=[VlanID].)

In VS mode, this log is supported only by the admin VS.

Parameters

Parameter Name	Parameter Meaning
ChassisID	Chassis ID of the interface where a loop occurs.
SlotID	Slot ID of the interface where a loop occurs. When a device works in 1:1 backup mode, the slot ID is displayed as 0.
IfName	Name of the interface where a loop occurs.
VlanID	ID of the VLAN that the interface joins. If the interface is a member of a VLANIF interface, the VLANID value ranges from 1 to 4094. If the interface is not a member of a VLANIF interface, the VLANID value is 0.

Possible Causes

Cause 1:The alarm indicating an interface loop was cleared.
Cause 2:Adjust the corresponding CAR value.

Procedure

This trap message is informational only, and no action is required.