DEVM/1/hwBoardFail_clear

Message

DEVM/1/hwBoardFail_clear: The board resumed from partial failure. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=[EntityTrapFaultID], Reason=[Reason])

In VS mode, this log is supported only by the admin VS.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity.
EntityType	Indicates the type of the physical entity. The value can be one of the following: -1: mpu(1) -2: lpu(2) -3: sfu(3) -4: pic(4) -5: cfcard(5) -6: ofc(6) -7: board(7) -255: other(255)
EntityTrapFaultID	Indicates the error code.
Reason	Indicates the description of the cause of the trap.

Possible Causes

Cause 132096:Power supply for a board recovered.
Cause 132097:The MonitorBus of the board recovered.
Cause 132098:The sc chip resumed from failure.
Cause 132100:The fault that the board was not installed in a proper slot was rectified.
Cause 132101:The supply voltage 48V of the board is normal.
Cause 132102:The board recovered from a power-on/power-off failure.
Cause 132103:The battery of the MPU recovered.
Cause 132104:The fault that signals obtained by the board from the master and slave MPUs were incorrect was rectified.
Cause 132105:The sensor on the board recovered.
Cause 132108:The clock signal of the board recovered.
Cause 132109:The fault that the voltage of the board exceeded the upper fatal threshold was rectified.
Cause 132110:The fault that the voltage of the board exceeded the upper warning threshold was rectified.
Cause 132111:The fault that the voltage of the board was lower than the lower fatal threshold was rectified.
Cause 132112:The fault that the voltage of the board was lower than the lower warning threshold was rectified.
Cause 132117:The clock signal on the board was recovered.
Cause 132118:The in-position signal of the board became normal.
Cause 132120:The IIC bus of the board is normal.
Cause 132121:The USB controller on the board was recovered.
Cause 132122:The CFcard of the MPU board is normal.
Cause 132127:Faults with the board clock are rectified.
Cause 132128:Faults with the board PLL are rectified.
Cause 132129:Faults with the FE PHY chip are rectified
Cause 132131:The fault on the key chip of the clock board was recovered.
Cause 132134:Faults with LANSWITCH are rectified.
Cause 132137:The alarm that indicated the CMAC chip failed the self check was cleared.
Cause 132139:The fault that the voltage of the subcard exceeded the upper fatal threshold was rectified.
Cause 132140:The fault that the voltage of the board exceeded the upper warning threshold was rectified.
Cause 132141:The fault that the voltage of the subcard was below the lower fatal threshold was rectified.
Cause 132142:The fault that the voltage of the board was below the lower warning threshold was rectified.
Cause 132150:The idle space on the CF card is higher than the threshold
Cause 132152:The CPU of the board resumed from partial failure.
Cause 132155:The link between the CMAC chip and the NP chip was detected ok.
Cause 132157:The multicast traffic of the board is normal.
Cause 132161:Faults with temperature sensors are rectified.
Cause 132163:The Core of the Board is normal.
Cause 132164:The sensor points are normal.
Cause 132169:The communication channel is normal.
Cause 132170:The RTC of MPU board is normal.
Cause 132173:The Security Acceleration Engine is normal.
Cause 132174:Fault with PCB corrosive is rectified
Cause 132177:Fault with interface MAC CRC is rectified
Cause 132178:Fault with e-label CRC is rectified
Cause 132180:The first 48V power supply of the board is normal.
Cause 132181:The second 48V power supply of the board is normal.
Cause 132182:Faults with voltage sensors are rectified.
Cause 132183:Faults with voltage A/D are rectified.
Cause 132184:Fault with SPI bus is rectified
Cause 132187:The cp2np-phy on the board is normal.
Cause 132188:The link between CPU and NP was detected faulty.
Cause 132191:The slave MPU reset signal of the board is normal.
Cause 132192:Fault with board Id is rectified.
Cause 132193:The storage life cycle is normal.
Cause 132198:The encryption and decryption acceleration engine is normal.
Cause 132204:The cpu frequency of the board is normal.
Cause 132248:enable secure boot successfully.
Cause 132255:Faults with the board working clock are rectified.
Cause 132273:The management network is normal.
Cause 132274:The Ethernet interface of Forward Engine is normal.
Cause 132305:Device certificate verify success.
Cause 132307:The CPU MCU is normal
Cause 132425:The FPGA1 logic of the board is normal.
Cause 132426:The FPGA2 logic of the board is normal.
Cause 132427:The FPGA3 logic of the board is normal.
Cause 132428:The FPGA4 logic of the board is normal.
Cause 132429:The FPGA5 logic of the board is normal.
Cause 132638:The intelligent heartbeats are normal.
Cause 132665:The NP back pressure status is normal.

Procedure

Cause 132096:Power supply for a board recovered.
This log message is informational only, and no action is required.
Cause 132097:The MonitorBus of the board recovered.
This log message is informational only, and no action is required.
Cause 132098:The sc chip resumed from failure.
This log message is informational only, and no action is required.
Cause 132100:The fault that the board was not installed in a proper slot was rectified.
This log message is informational only, and no action is required.
Cause 132101:The supply voltage 48V of the board is normal.
This log message is informational only, and no action is required.
Cause 132102:The board recovered from a power-on/power-off failure.
This log message is informational only, and no action is required.
Cause 132103:The battery of the MPU recovered.
This log message is informational only, and no action is required.
Cause 132104:The fault that signals obtained by the board from the master and slave MPUs were incorrect was rectified.
This log message is informational only, and no action is required.
Cause 132105:The sensor on the board recovered.
This log message is informational only, and no action is required.
Cause 132108:The clock signal of the board recovered.
This log message is informational only, and no action is required.
Cause 132109:The fault that the voltage of the board exceeded the upper fatal threshold was rectified.
This log message is informational only, and no action is required.
Cause 132110:The fault that the voltage of the board exceeded the upper warning threshold was rectified.
This log message is informational only, and no action is required.
Cause 132111:The fault that the voltage of the board was lower than the lower fatal threshold was rectified.
This log message is informational only, and no action is required.
Cause 132112:The fault that the voltage of the board was lower than the lower warning threshold was rectified.
This log message is informational only, and no action is required.
Cause 132117:The clock signal on the board was recovered.
This log message is informational only, and no action is required.
Cause 132118:The in-position signal of the board became normal.
This log message is informational only, and no action is required.
Cause 132120:The IIC bus of the board is normal.
This log message is informational only, and no action is required.
Cause 132121:The USB controller on the board was recovered.
This log message is informational only, and no action is required.
Cause 132122:The CFcard of the MPU board is normal.
This log message is informational only, and no action is required.
Cause 132127:Faults with the board clock are rectified.
This log message is informational only, and no action is required.
Cause 132128:Faults with the board PLL are rectified.
This log message is informational only, and no action is required.
Cause 132129:Faults with the FE PHY chip are rectified
This log message is informational only, and no action is required.
Cause 132131:The fault on the key chip of the clock board was recovered.
This log message is informational only, and no action is required.
Cause 132134:Faults with LANSWITCH are rectified.
This log message is informational only, and no action is required.
Cause 132137:The alarm that indicated the CMAC chip failed the self check was cleared.
This log message is informational only, and no action is required.
Cause 132139:The fault that the voltage of the subcard exceeded the upper fatal threshold was rectified.
This log message is informational only, and no action is required.
Cause 132140:The fault that the voltage of the board exceeded the upper warning threshold was rectified.
This log message is informational only, and no action is required.
Cause 132141:The fault that the voltage of the subcard was below the lower fatal threshold was rectified.
This log message is informational only, and no action is required.
Cause 132142:The fault that the voltage of the board was below the lower warning threshold was rectified.
This log message is informational only, and no action is required.
Cause 132150:The idle space on the CF card is higher than the threshold
This log message is informational only, and no action is required.
Cause 132152:The CPU of the board resumed from partial failure.
This log message is informational only, and no action is required.
Cause 132155:The link between the CMAC chip and the NP chip was detected ok.
This log message is informational only, and no action is required.
Cause 132157:The multicast traffic of the board is normal.
This log message is informational only, and no action is required.
Cause 132161:Faults with temperature sensors are rectified.
This log message is informational only, and no action is required.
Cause 132163:The Core of the Board is normal.
This log message is informational only, and no action is required.
Cause 132164:The sensor points are normal.
This log message is informational only, and no action is required.
Cause 132169:The communication channel is normal.
This log message is informational only, and no action is required.
Cause 132170:The RTC of MPU board is normal.
This log message is informational only, and no action is required.
Cause 132173:The Security Acceleration Engine is normal.
This log message is informational only, and no action is required.
Cause 132174:Fault with PCB corrosive is rectified
This log message is informational only, and no action is required.
Cause 132177:Fault with interface MAC CRC is rectified
This log message is informational only, and no action is required.
Cause 132178:Fault with e-label CRC is rectified
This log message is informational only, and no action is required.
Cause 132180:The first 48V power supply of the board is normal.
This log message is informational only, and no action is required.
Cause 132181:The second 48V power supply of the board is normal.
This log message is informational only, and no action is required.
Cause 132182:Faults with voltage sensors are rectified.
This log message is informational only, and no action is required.
Cause 132183:Faults with voltage A/D are rectified.
This log message is informational only, and no action is required.
Cause 132184:Fault with SPI bus is rectified
This log message is informational only, and no action is required.
Cause 132187:The cp2np-phy on the board is normal.
This log message is informational only, and no action is required.
Cause 132188:The link between CPU and NP was detected faulty.
This log message is informational only, and no action is required.
Cause 132191:The slave MPU reset signal of the board is normal.
This log message is informational only, and no action is required.
Cause 132192:Fault with board Id is rectified.
This log message is informational only, and no action is required.
Cause 132193:The storage life cycle is normal.
The storage life cycle is normal, no action is required.
Cause 132198:The encryption and decryption acceleration engine is normal.
The encryption and decryption acceleration engine is normal, no action is required.
Cause 132204:The cpu frequency of the board is normal.
This log message is informational only, and no action is required.
Cause 132248:enable secure boot successfully.
This log message is informational only, and no action is required.
Cause 132255:Faults with the board working clock are rectified.
This log message is informational only, and no action is required.
Cause 132273:The management network is normal.
This log message is informational only, and no action is required.
Cause 132274:The Ethernet interface of Forward Engine is normal.
This log message is informational only, and no action is required.
Cause 132305:Device certificate verify success.
This log message is informational only, and no action is required.
Cause 132307:The CPU MCU is normal
This log message is informational only, and no action is required.
Cause 132425:The FPGA1 logic of the board is normal.
This log message is informational only, and no action is required.
Cause 132426:The FPGA2 logic of the board is normal.
This log message is informational only, and no action is required.
Cause 132427:The FPGA3 logic of the board is normal.
This log message is informational only, and no action is required.
Cause 132428:The FPGA4 logic of the board is normal.
This log message is informational only, and no action is required.
Cause 132429:The FPGA5 logic of the board is normal.
This log message is informational only, and no action is required.
Cause 132638:The intelligent heartbeats are normal.
This log message is informational only, and no action is required.
Cause 132665:The NP back pressure status is normal.
This log message is informational only, and no action is required.