DEVM/2/hwBrdTempAlarm_clear

Message

DEVM/2/hwBrdTempAlarm_clear: The alarm indicating that the board temperature exceeded the upper alarm threshold was cleared. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityThresholdType=[EntityThresholdType], EntityThresholdCritical=[EntityThresholdCritical], EntityThresholdCurrent=[EntityThresholdCurrent], EntityTrapFaultID=[EntityTrapFaultID], Reason=[Reason])

In VS mode, this log is supported only by the admin VS.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity, such as "SFU \| LPU \| MPU slot slotID". The entity name varies according to the board type, such as the SFU, LPU, and MPU.
EntityThresholdType	The abnormal type for temperature.The value can be: 1:high 2:low
EntityThresholdCritical	The warning alarm threshold for warning alarm.
EntityThresholdCurrent	The current value that been measured.
EntityTrapFaultID	To describe the fault id of trap.
Reason	Indicates the description of the cause of the trap.

Possible Causes

Cause 143616:The subcard temperature is normal.
Cause 143617:The board temperature is normal.
Cause 143618:The fan temperature is normal.
Cause 143619:The board temperature became normal.
Cause 143620:The subcard temperature became normal.
Cause 143621:The fan temperature became normal.
Cause 143622:The power module temperature became normal.
Cause 143623:The power module temperature dropped to a normal level.

Procedure

This trap message is informational only, and no action is required.