NAT/4/hwCGNUserTableThresholdAlarm_active

Message

NAT/4/hwCGNUserTableThresholdAlarm_active: The number of user tables reached the upper limit. (UserTableNum=[UserTableNum],Threshold=[Threshold],Slot=[Slot], Cpu=[Cpu])

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The number of NAT user tables reached the threshold.

Parameters

Parameter Name	Parameter Meaning
UserTableNum	Number of user tables that are used.
Threshold	Threshold of the proportion of used user tables to the total supported ones.
Slot	Slot ID of a service board.
Cpu	CPU ID of the service board.

Possible Causes

The proportion of configured user tables to the total supported ones on a service board's forwarding engine reached a specified threshold.

Procedure

1.Run the display nat user-information command. Then check the information of NAT users whether the proportion of used NAT user tables reaches the specified threshold.

If the proportion reaches the specified threshold, go to Step 2.
If the proportion does not reach the specified threshold, go to Step 3.

2.Run the nat alarm user-table threshold command in the system view to increase the threshold. Check whether the trap is cleared.

If the trap is cleared, go to Step 4.
If the trap persists, go to Step 3.

3.Collect trap, log, and configuration information, and then contact technical support personnel.

4.End.