PIC/1/hwCardFail_active-135168

Message

PIC/1/hwCardFail_active: The card failed partially. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityType=[EntityType], EntityTrapFaultID=135168, Reason=The monitoring channel of the subcard was faulty.)

In VS mode, this log is supported only by the admin VS.

Description

The subcard experienced a partial failure.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity.
EntityType	Indicates the type of the physical entity.
EntityTrapFaultID	Indicates the error code.
Reason	Indicates the description of the cause of the trap.

Possible Causes

The monitoring channel of the subcard was faulty.

Procedure

1. Power off the subcard and then power it on again. Check if the alarm is cleared.

If the alarm is cleared, go to Step 3.
If the alarm is not cleared, go to Step 2.

2. Collect alarm information, log information and configuration information, and then contact technical support personnel.

3. End.