DEVM/1/hwChassisFail_active-131345

Message

DEVM/1/hwChassisFail_active: The chassis failed partially. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityTrapFaultID=131345, Reason=CMUs were not fully configured.)

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The chassis experienced a partial failure.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity, such as chassis.
EntityTrapFaultID	Indicates the error code.
ReasonDescription	Indicates the description of the cause of the trap.

Possible Causes

CMUs were not fully configured.

Procedure

1. Check whether CMUs are fully configured.

If not, go to Step 2.
If so, go to Step 3.

2. Install CMUs based on configuration requirements, then check whether the alarm persists.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 3.

3. Collect trap, log, and configuration information, and contact technical support.

4. End.